Drawing View
Drawing View
(OP)
Hello All,
Thank you in advance. I'm having some trouble drawing the attached drawing. I was able with no problem to draw the top, but the bottom/underneath is what I'm having trouble seeing. Can someone please help me with this. Maybe I'm looking at it wrong or something. (the dashed lines are my main issues)
BR
Kenjg
Thank you in advance. I'm having some trouble drawing the attached drawing. I was able with no problem to draw the top, but the bottom/underneath is what I'm having trouble seeing. Can someone please help me with this. Maybe I'm looking at it wrong or something. (the dashed lines are my main issues)
BR
Kenjg






RE: Drawing View
As for the how, I would create the rectangle and extrude it the 5mm. I would then create a sketch for the 5 cutouts and create them. Bear in mind that you can use a sketch in multiple features.
After that I would create the hole features.
Jeff Mirisola, CSWE
My Blog
RE: Drawing View
Thank you for your reply. Sorry for the late response. I was able to complete the top side of the drawing. It's ALL the dashed lines on the bottom I'm having trouble deciphering. I just can't see what it is that needs to be done.
One way or another I'll figure it out.
BR
Ken
RE: Drawing View
http://en.wikipedia.org/wiki/Multiview_orthographic_projection
Eric