Conic Tube
Conic Tube
(OP)
We're triying to find a company willing to make a 316 SS conic pipe 252mm long.
Too see the print please follow this link:
http://www.vega-web.it/prints/tubo.jpg
Thanks for any suggestions.
Too see the print please follow this link:
http://www.vega-web.it/prints/tubo.jpg
Thanks for any suggestions.





RE: Conic Tube
RE: Conic Tube
1. Using a EDM machine and a pipe with a smaller inner dia. then 3.45 (outer dimensions - as drawing), the wire could give you the taper required and if done slowly can reach the surface finish tolerances
2. Make a conical bar with the dimensions of the inner part.
Then get a bar with a large inner and outer dia then the one required and press it around the conical bar (by using what I think is called a mandrial - not sure of name) to get the require shape.
John