Is there a minimum or maximum recommended "working" thickness of chrome for the contact surface of a shaft and viton lip seal ? I figure we initially need some "extra " to allow finishing, and to compensate for variations in the machining that reduces shaft diameter prior to chroming.
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
PCB design is a purposeful process. In essence, every PCB design is a complex puzzle that requires a designer to incorporate critical components and tight schematics into a piece of technology that is governed by rules, constraints and industry standards. Download Now