V5 R20 Change defining view of a section view
V5 R20 Change defining view of a section view
(OP)
I have inherited a drawing that has a section view, Section A-A.
Unfortunately the defining view for Section A-A is incorrectly orientated.
Does anyone know a way to change Section A-A to be called out from a new view without re-creating it?
This will save a lot of time as there are other views called out from Section A-A.
Unfortunately the defining view for Section A-A is incorrectly orientated.
Does anyone know a way to change Section A-A to be called out from a new view without re-creating it?
This will save a lot of time as there are other views called out from Section A-A.





RE: V5 R20 Change defining view of a section view
RE: V5 R20 Change defining view of a section view
I really need something that points the section view to a new view.
RE: V5 R20 Change defining view of a section view
indocti discant et ament meminisse periti
RE: V5 R20 Change defining view of a section view
It is the rotation of the defining view of the section.
I am not sure how it was generated in the first place but it is has the XZ plane rotated 16 degrees from the model which means that all the child views are incorrect.
RE: V5 R20 Change defining view of a section view
indocti discant et ament meminisse periti
RE: V5 R20 Change defining view of a section view
What I need to do is change the definition from one parent view to a new parent view.
RE: V5 R20 Change defining view of a section view
indocti discant et ament meminisse periti
RE: V5 R20 Change defining view of a section view
Aside from that, the functionality you're describing sounds like a V4 functionality that if V5 replicated it, I haven't found it yet.
RE: V5 R20 Change defining view of a section view
indocti discant et ament meminisse periti
RE: V5 R20 Change defining view of a section view
I have now recreated all the views below the original parent.