File opening message
File opening message
(OP)
I'm an amateur SE user, having used the various versions for about 6 years.
Recently, when trying to open a SE file, I receive a dialog window containing the text "Cannot open this file. No translator is available for this file type."
The files in question are of SE ST4 origin.
Does anyone have any idea what has happened to the files to cause this message, and any suggestions for recovery please?
Recently, when trying to open a SE file, I receive a dialog window containing the text "Cannot open this file. No translator is available for this file type."
The files in question are of SE ST4 origin.
Does anyone have any idea what has happened to the files to cause this message, and any suggestions for recovery please?





RE: File opening message
Older versions of SE will not open files created in newer versions.
What is Engineering anyway: FAQ1088-1484: In layman terms, what is "engineering"?
RE: File opening message
Ken G.
http://grundey.blogspot.com
Have you checked out the Solid Edge Community site?
http://community.plm.automation.siemens.com/t5/Sol...
RE: File opening message
And its not the 'student' version!
Thanks for the prompt replies, much appreciated.
Mike
RE: File opening message
This was a typical error we received, and I don't know why a MP acts like a different version, but it has been the past few SE ST releases. Update to the latest ST4 maintenance pack and you should be fine.
--Scott
www.wertel.pro