section line in broken view (NX8)
section line in broken view (NX8)
(OP)
If you try to section broken view / or to broke view which already have any sections, the section line disappears. Is it normal?
win 7 64bit, NX8.0.3.4
win 7 64bit, NX8.0.3.4





RE: section line in broken view (NX8)
Note that we are aware of this issue, but if you would like to contact GTAC and express your desire that NX support this correctly, please do so.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: section line in broken view (NX8)
RE: section line in broken view (NX8)
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: section line in broken view (NX8)
Thanks.
RE: section line in broken view (NX8)
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: section line in broken view (NX8)
RE: section line in broken view (NX8)
If you have NX open, go to Help -> online technical support -> log an incident with technical support. This option will open a form on the GTAC website that you can fill out with the necessary information.
www.nxjournaling.com