Special output options for local MCS not working as expected
Special output options for local MCS not working as expected
(OP)
Hello,
I am puzzled by output from NX. In the attached part file, I have a main MCS and then I have a local MCS. But whatever option I chose for 'Special Output' (None, Main, Fixture offset, CSYS rotation), the output clsf is the same.
Am I missing something?
I am puzzled by output from NX. In the attached part file, I have a main MCS and then I have a local MCS. But whatever option I chose for 'Special Output' (None, Main, Fixture offset, CSYS rotation), the output clsf is the same.
Am I missing something?





RE: Special output options for local MCS not working as expected
These options are intended for NX/Post Postprocessors, using the mom event architecture.
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: Special output options for local MCS not working as expected