Only 5 events available in NX User Defined Event (UDE) dialog box
Only 5 events available in NX User Defined Event (UDE) dialog box
(OP)
Hello everyone,
I used Start and End events in NX before. Recently, we switched to NX9 and when I open the UDE dialog box, I only see 5 available events: GOTO, FROM, GOHOME, Spindle and Toolchange markers.
I have uploaded a screen capture here: http://postimg.org/image/iovhe7mhb/
If you can figure it out, can someone tell me why I am able to see only the 5 above events as available?
Thanks!
gnv
I used Start and End events in NX before. Recently, we switched to NX9 and when I open the UDE dialog box, I only see 5 available events: GOTO, FROM, GOHOME, Spindle and Toolchange markers.
I have uploaded a screen capture here: http://postimg.org/image/iovhe7mhb/
If you can figure it out, can someone tell me why I am able to see only the 5 above events as available?
Thanks!
gnv





RE: Only 5 events available in NX User Defined Event (UDE) dialog box