Normal Views
Normal Views
(OP)
When I am in part designer, and I do a NORMAL VIEW on a surface or plane....it works fine, I can see my normal view....For example, I click on NORMAL VIEW, and then on the XY plane, and it goes to the parallel view, but the X-AXIS, for example, is not aligned at 0 degrees...it always seems to be off at some angle. Like, my whole part is tilted at an angle...How can I correct this?
Regards,
Max...
maxshiff@sympatico.ca
Regards,
Max...
maxshiff@sympatico.ca





RE: Normal Views
If you dont select an objet with an axis, something like a sketch, the view wont turn to have H,V correctly.
You can set some working support, that might help you.
Have fun,
Eric
catiav5@softhome.net