I am running FEA simulations in Abaqus - I want to model dense, dry silica sand with grain diameters of approximately 0.3 mm. I'm using the Drucker Prager Cap model to simulate deformation. Does anyone know where I can find some triaxial test data to determine the parameters? I've been looking around but can't seem to find anything satisfactory. I'm wondering if there's some handbook with triaxial test results for different materials? Does anyone have any suggestions where I can find some data?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Since the later 1980s, manufacturing companies have seen over 3 percent in labor output year on year, with most of this productivty enhancement occuring because of the optimization of repetitive tasks. Download Now