NX7.5/8.5 to NX9.0 Impeller Problem
NX7.5/8.5 to NX9.0 Impeller Problem
(OP)
Hey Folks,
I am trying to replicate the Impeller Assembly assignment from NX7.5/8.5 in 9.0 and I am having some trouble with the Impeller Vanes. I Trim the vanes back OK but when I try to add the Variable Edge Blend Radii, the vanes believe they are hollow. And I am also having trouble with the Instances of the vanes. Could you help??
I am trying to replicate the Impeller Assembly assignment from NX7.5/8.5 in 9.0 and I am having some trouble with the Impeller Vanes. I Trim the vanes back OK but when I try to add the Variable Edge Blend Radii, the vanes believe they are hollow. And I am also having trouble with the Instances of the vanes. Could you help??





RE: NX7.5/8.5 to NX9.0 Impeller Problem
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.