×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Mesh size

Mesh size

Mesh size

(OP)
Just one quick question.

How do you determine mesh size? Far as I know, general rule is that element cannot be smaller than t x t (t being thickness of plate that is meshed).

Thank you!

RE: Mesh size

the elements can be as small as you want, though their accuracy may suffer. run some simple tests ... axially loaded, bending (in-plane), ...

another day in paradise, or is paradise one day closer ?

RE: Mesh size

That is a open ended question and not easily answered. Basically the mesh has to be fine enough to capture the solution with the accuracy you require. How small is that? It depends on many things and cant be easily answered here. Obviously mesh must be better in regions where stress concentrations/constraints/loads exist. Typically I personally start large to make sure model behaves properly and refine in regions you care about until the solution stops changing. After awhile you get some knowledge based on experience.

RE: Mesh size

Dear Jose Andres,
The answer is in your hand: you need to prepare different studies and compare results, with double DOF, reduce the element size on each study to have more or less the double DOF. Run the stress analysis and compare stress results in different points of you FE model (for instance, use vonMises nodal stress for comparison), if the solution do not vary more than 5% (others say 8%) then the solution is "mesh undependant", ie, your solution has converged to correct stress results.

Please note convergence in displacements is achieved inmediately, but in stresses your need to perform a few iterations. Also, select points to read stresses not coincident with hot spots, for instance a corner point. The reason: the local stress concentration at this point is a stress singularity, so if you continue refining mesh the stress will never converge, and then this point is not valid for assessment of stress analysis. This is because the theoretical elastic stress at the corner is infinite.

Best regards,
Blas.

~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director

IBERISA
48004 BILBAO (SPAIN)
WEB: http://www.iberisa.com
Blog de FEMAP & NX Nastran: http://iberisa.wordpress.com/

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources