How to delete a partition during a job.
How to delete a partition during a job.
(OP)
Hi,
I need to make some simulations of a wall drilled in 2D on Abaqus. I need to know if is there any possibility to apply heat flux, and then eliminate a partition, all in the same job. I've been looking in the 'Steps' but I don't find the way.
Thanks in advance.
Regards.
I need to make some simulations of a wall drilled in 2D on Abaqus. I need to know if is there any possibility to apply heat flux, and then eliminate a partition, all in the same job. I've been looking in the 'Steps' but I don't find the way.
Thanks in advance.
Regards.




