Plastic Hinge Workbench (VMMECH029)
Plastic Hinge Workbench (VMMECH029)
(OP)
thread569-306821: Ansys Workbench nonlinear plastic analysis
Referring to the Thread (above) i want to ask about examples from verification manual VMMECH029
For 30000 lbf-in ansys returns exact solution, but for bigger moment it cannot converge. In the previous Thread it was recommended to set:
Element Control in Geometry - Manual
Brick Integration Scheme in Solid - Full
However, I cannot find it in the Workbench 15. Is it possible to obtain (nearly) plastic hinge for elastic perfectly-plastic model like in VMMECH029?
Referring to the Thread (above) i want to ask about examples from verification manual VMMECH029
For 30000 lbf-in ansys returns exact solution, but for bigger moment it cannot converge. In the previous Thread it was recommended to set:
Element Control in Geometry - Manual
Brick Integration Scheme in Solid - Full
However, I cannot find it in the Workbench 15. Is it possible to obtain (nearly) plastic hinge for elastic perfectly-plastic model like in VMMECH029?




