How to Constrain an Ellipse in a Sketch in NX9?
How to Constrain an Ellipse in a Sketch in NX9?
(OP)
Looks like I am covering some new ground at work with ellispes, but... how does a person contrain an ellipse created in a sketch in NX9? Is it something that can be constrained? If not, I ask those in the audience that used Check-Mate or manually check for a fully contrained sketch deal if it is something that cannot be constrained?





RE: How to Constrain an Ellipse in a Sketch in NX9?
RE: How to Constrain an Ellipse in a Sketch in NX9?
CAD -> Sketching -> creating sketch curves -> ellipse -> fully constrain an ellipse
www.nxjournaling.com