STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
(OP)
Good morning,
I have imported from Catia in NX a stp file from a solid.
The conversion looks strange.......The solid has face/s that is not shown!
I do not get it!
Could you find what the problem is?
Thanks
I have imported from Catia in NX a stp file from a solid.
The conversion looks strange.......The solid has face/s that is not shown!
I do not get it!
Could you find what the problem is?
Thanks
MZ7DYJ





RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
MZ7DYJ
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
MZ7DYJ
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
Anthony Galante

Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.2, NX10 Beta
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
I tried that but it doesn't work.........
MZ7DYJ
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
My bad...it works!......
Thanks a lot!
MZ7DYJ
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
regards
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
One of the faces is a "Non manifold" condition which NX/ Parasolid don't like but which the Heal geometry cures.
Regards,
Tomas
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
MZ7DYJ
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
what i am saying is that one face of the imported body is "corrupt", selfintersecting. Probably due to that Catia and Parasolids handles "special cases" differently.
See attached image. Screenshot in wireframe display mode.
Regards,
Tomas
RE: STP CONVERSION FROM CATIA TO NX (FACE ERRPR) - NX8
Thanks a gain!
MZ7DYJ