NX ALL VERSIONS - DIMENSION END WRONG
NX ALL VERSIONS - DIMENSION END WRONG
(OP)
Have any of you seen this before: sometimes, for unokwn reasons, NX is selecting the opposite end of a sketch curve while in Inferred Dimensioning...
I have attached a illustration herewith.

I have attached a illustration herewith.






RE: NX ALL VERSIONS - DIMENSION END WRONG
www.jcb.com
NX 8.5 with TC 8.3
RE: NX ALL VERSIONS - DIMENSION END WRONG
RE: NX ALL VERSIONS - DIMENSION END WRONG
If the error is still there in the new session, it's qualified for GTAC.
Regards,
Tomas