laser cut
laser cut
(OP)
how it's going I needed some help since I'm having trouble cutting 0.187HRS with oxygen, I'm using the FO3015NT laser
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: laser cut
TTFN

FAQ731-376: Eng-Tips.com Forum Policies
Need help writing a question or understanding a reply? forum1529: Translation Assistance for Engineers
Of course I can. I can do anything. I can do absolutely anything. I'm an expert!
RE: laser cut
1. material has rust. they usually will palm sand rust off for better results.
2. oxygen pressure too high (or low), especially in tight geometries, causing blowouts.
3. then you have the usual suspects like with everything else like focus, feedrate etc.
What exactly is your problem? Blow outs, hard dross, edge quality?
"I am stuck on Band-Aid brand, 'cause they are stuck on me"