Making new assembly from existing one (Teamcenter 9)
Making new assembly from existing one (Teamcenter 9)
(OP)
Hi,
In TEAMCENTRE 9 (NX 8.5) I have an old project, from which I have to create new one. Select top
assembly and make new item for everything inside.
I need that all wave links and drawings links are intact.
What is correct way to do it?
In TEAMCENTRE 9 (NX 8.5) I have an old project, from which I have to create new one. Select top
assembly and make new item for everything inside.
I need that all wave links and drawings links are intact.
What is correct way to do it?





RE: Making new assembly from existing one (Teamcenter 9)
Khimani Mohiki
Design Engineer - PENSO Consulting Ltd
RE: Making new assembly from existing one (Teamcenter 9)
RE: Making new assembly from existing one (Teamcenter 9)
Not sure if this will retain your WAVE links though
Khimani Mohiki
Design Engineer - PENSO Consulting Ltd
RE: Making new assembly from existing one (Teamcenter 9)