VIEW BREAK - NX8
VIEW BREAK - NX8
(OP)
Hi,
I'd like to create a view break that would finally show the yellow side of the part with an offset of, let's say, 10mm in each side.
How could I do this break view?
I tried but I can’t get totally the middle side of the part!
Thanks
I'd like to create a view break that would finally show the yellow side of the part with an offset of, let's say, 10mm in each side.
How could I do this break view?
I tried but I can’t get totally the middle side of the part!
Thanks
MZ7DYJ





RE: VIEW BREAK - NX8
What I'd like to know is how to apply the Regular one in this particular case......
MZ7DYJ
RE: VIEW BREAK - NX8
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: VIEW BREAK - NX8
MZ7DYJ