Unigraphics Error Message
Unigraphics Error Message
(OP)
Hello!
I am getting an error message when trying to open a unigraphics file.
The file loads to about 45% and then crashes and an error message saying "The attribute title is null" comes up.
I tried opening this on another computer and get the same message. I tried shortening the name of the file and still get the same message. I tried opening it from my local drive and still get this message.
Any help would be greatly appreciated !
I am getting an error message when trying to open a unigraphics file.
The file loads to about 45% and then crashes and an error message saying "The attribute title is null" comes up.
I tried opening this on another computer and get the same message. I tried shortening the name of the file and still get the same message. I tried opening it from my local drive and still get this message.
Any help would be greatly appreciated !





RE: Unigraphics Error Message
Is it an assembly ?
RE: Unigraphics Error Message
I was able to figure it out... I was opening it in UG8.5 and tried opening it in UG8 and it worked
RE: Unigraphics Error Message
www.nxjournaling.com
RE: Unigraphics Error Message
It is a PRT file of an assembly that I am trying to open.
It is weird because I am actually able to open other files in the same zip file that was sent to be in UG8.5 except for this one
RE: Unigraphics Error Message
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Unigraphics Error Message
I ran a part clean up on the part and tried opening it in UG8.5 but still get the same error message
RE: Unigraphics Error Message
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Unigraphics Error Message
I see you reached the "1000 votes" mark.
I think you should bring donuts tomorrow to celebrate.
RE: Unigraphics Error Message
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Unigraphics Error Message
Information about ug_inspect and its use can be found in the NX help files:
Fundamentals -> command line utilities -> inspect part files
www.nxjournaling.com