Need a diameter symbol on the inspection report?
Need a diameter symbol on the inspection report?
(OP)
Hi All:
This question posted in Drafting Standards, GD&T & Tolerance Analysis Forum, perhaps here is the right place for this question, in order to prevent duplicate the same question, you are welcome to view the link below, and thanks for your inputs in advance.
http://www.eng-tips.com/viewthread.cfm?qid=371493
Thanks
Season
This question posted in Drafting Standards, GD&T & Tolerance Analysis Forum, perhaps here is the right place for this question, in order to prevent duplicate the same question, you are welcome to view the link below, and thanks for your inputs in advance.
http://www.eng-tips.com/viewthread.cfm?qid=371493
Thanks
Season




