Drawing: part is locked in "Reference only"
Drawing: part is locked in "Reference only"
(OP)
I have a problem.
I use NX8.5 and TC9.1, i have imported some parts and drawings into teamcenter.
When i open the drawing the part stands as "Reference Only" and i can´t change this, under properties the "Reference only"-box i grey.
This causes the BOM-list to fail.
Any suggestions how to solve this problem?
I use NX8.5 and TC9.1, i have imported some parts and drawings into teamcenter.
When i open the drawing the part stands as "Reference Only" and i can´t change this, under properties the "Reference only"-box i grey.
This causes the BOM-list to fail.
Any suggestions how to solve this problem?





RE: Drawing: part is locked in "Reference only"
I haven't got NX at home, I'll have a look when I get into the office tomorrow if no-one else can help until then.
RE: Drawing: part is locked in "Reference only"
RE: Drawing: part is locked in "Reference only"
Mike Hyde
www.astonmartin.com
NX8.5 with TC9.1
RE: Drawing: part is locked in "Reference only"
I get the alert:
"This attribute cannot be set/modified on this object, as it is locked"
And the information under Inherited:
"Attribute is inherited from the component instance"
is there any way to unlock the attribute?
RE: Drawing: part is locked in "Reference only"
This is an unusual attribute as it is only valid for a specific instance in an assembly or drawing.
Mike Hyde
www.astonmartin.com
NX8.5 with TC9.1