I have a dumb question: In our control cabinet, we run several motors off the 3phase, 460V line. I need to add another branch circuit. I have the motor starter, reverser, motor, etc, but what do I do about the wiring? I've noticed that the terminals of the other motor starters use two wires in two-wire ferrules. I don't at this time have a special tool to crimp two-wire ferrules. Is the method to daisy-chain each branch? >help<
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.