Shaded View too dark in Drawing (SW 2010)
Shaded View too dark in Drawing (SW 2010)
(OP)
This doesn't seem to be possible (at least not in release 2010)-though it should be:
Being able to adjust "lights" in a drawing-individually from the actual model. I know this sounds counter-intuitive, but sometimes the shaded view in the drawing is darker than the shaded view in the model. There seems to be no easier way than making the shaded view in the model too bright, so that it's bright enough in the drawing.
Being able to adjust "lights" in a drawing-individually from the actual model. I know this sounds counter-intuitive, but sometimes the shaded view in the drawing is darker than the shaded view in the model. There seems to be no easier way than making the shaded view in the model too bright, so that it's bright enough in the drawing.






RE: Shaded View too dark in Drawing (SW 2010)
Video card?
Chris, CSWA
SolidWorks 14
ctopher's home
SolidWorks Legion
RE: Shaded View too dark in Drawing (SW 2010)
Maybe I'll mess with the Display States - I've found they can be a little screwy sometimes, too.