Gage R&R
Gage R&R
(OP)
I'm new to gage r&r studies and I have a beginner question. When performing a gage r&r, is it required to record the lot/serial# of the parts being used? More importantly, for the medical device industry, is it required or just good practice?





RE: Gage R&R
All we were required to record was the tool ID, standards we were measuring, and our results. This was submitted with paperwork that had our manufacturing lot numbers, customer part number, and our part number.
Sorry I am not exactly sure what your customer is requiring, but I dont think it would hurt anything. My customers have required it on the forms that they gave me to fill out.
________________________________
Ryan M
Quality Engineer
3d Printer Hobbyist