I have quite a complex assembly, and I want to make a General Assembly Drawing where I need to have two hole patterns visible. If I right click on the View of interest, click Edit View, and then change the style to wire frame with hidden lines, then there are waaay to many unwanted hidden lines for me to just delete all of them. So my question is, how do I just select one hole patterns hidden lines to show up in a drawing?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Since the later 1980s, manufacturing companies have seen over 3 percent in labor output year on year, with most of this productivty enhancement occuring because of the optimization of repetitive tasks. Download Now