Fillet modeling on propeller
Fillet modeling on propeller
(OP)
Dear all,
I have a model of propeller blade which was created in ANSYS multiphysics.
I have attached image of same with this thread .
I would like to model fillet in between blade and hub with certain radius. As blade is curvature in I can't use the option
extrude area -> along line .
Can anybody know how to model same ?
Thanking you
Regards,
sachin46
I have a model of propeller blade which was created in ANSYS multiphysics.
I have attached image of same with this thread .
I would like to model fillet in between blade and hub with certain radius. As blade is curvature in I can't use the option
extrude area -> along line .
Can anybody know how to model same ?
Thanking you
Regards,
sachin46





RE: Fillet modeling on propeller
there is a command in Ansys MAPLD for creating a fillet between two areas. Have you searched the Manual for that?
MESHPARTS
Tuning Your Simulation
http://www.meshparts.de
RE: Fillet modeling on propeller