NX8.5 assembly constraints won't display on screen
NX8.5 assembly constraints won't display on screen
(OP)
Hello,
I've just noticed, in existing (pre 8.5) assemblies, the constraints won't display on screen when using NX8.5.
I've done everything I can think (show and hide, show and hide in navigator, blank everything else, change the background colour, check layers, try wireframe) but nothing will make them show.
I also deleted all constraints then added a new one, still invisible.
BUT, if I create a brand new assembly they work just fine.
See image attached, does anyone know why this might be happening?
I've just noticed, in existing (pre 8.5) assemblies, the constraints won't display on screen when using NX8.5.
I've done everything I can think (show and hide, show and hide in navigator, blank everything else, change the background colour, check layers, try wireframe) but nothing will make them show.
I also deleted all constraints then added a new one, still invisible.
BUT, if I create a brand new assembly they work just fine.
See image attached, does anyone know why this might be happening?
www.jcb.com
NX 8.5 with TC 8.3





RE: NX8.5 assembly constraints won't display on screen
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX8.5 assembly constraints won't display on screen
Thank you John
www.jcb.com
NX 8.5 with TC 8.3