NX symbol question
NX symbol question
(OP)
Howdy All,
Anyone know if there is a way to default symbol placement to USE DEFINITION rather than USE CURRENT?
Running NX6.0.5.3 globally but would be handy to know if anything exists in later versions as well ;)
Thanks,
Ryan
Anyone know if there is a way to default symbol placement to USE DEFINITION rather than USE CURRENT?
Running NX6.0.5.3 globally but would be handy to know if anything exists in later versions as well ;)
Thanks,
Ryan





RE: NX symbol question
File -> Utilities -> Customer Defaults -> Drafting -> other symbols -> geometry preferences
RE: NX symbol question
Thank you, in NX8.5 that is exactly what I'm after. Any chance this exists elsewhere in NX6?
Thanks,
Ryan
RE: NX symbol question