cell fill
cell fill
(OP)
Hello,
Wondering if NX has a function to fill a cell in a table.... similar to background cell fill in excel. All I've been able to come up with thus far is to trace the cells with sketch curves and then use the solid area fill. I'm thinking there should be an easier way.
Currently running NX6.0.5.3 but if available in future version it would still be handy to know.
Thanks,
Ryan
Wondering if NX has a function to fill a cell in a table.... similar to background cell fill in excel. All I've been able to come up with thus far is to trace the cells with sketch curves and then use the solid area fill. I'm thinking there should be an easier way.
Currently running NX6.0.5.3 but if available in future version it would still be handy to know.
Thanks,
Ryan





RE: cell fill
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: cell fill
Thanks for the reply. Not what I was anticipating, but at least I know.
Thanks again,
Ryan