Spline of given length outside or Routing
Spline of given length outside or Routing
(OP)
Greetings all!
Is it possible to build a studio spline of a given length, not using Routing application? I know it is possible in Routing, but is it possible in a plain modeling mode?
Is it possible to build a studio spline of a given length, not using Routing application? I know it is possible in Routing, but is it possible in a plain modeling mode?
Industry creates wealth!





RE: Spline of given length outside or Routing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Spline of given length outside or Routing
The version that I mean is 8.5, but would be interested to know about the solution for 9.0 as well, if it is any different!
Industry creates wealth!
RE: Spline of given length outside or Routing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Spline of given length outside or Routing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Spline of given length outside or Routing
Industry creates wealth!