Help!! Error 734010
Help!! Error 734010
(OP)
Hello Eng-tips,
This morning I try to open an assembly file and after 45% Loading a warning message popUp as "Error During Update: Error number 734010, This was caused while updating of type Drafting Feature Control Frame in part xxx.prt" followed by another massage "Could not open xxx.prt...the following files could not loaded...open to fail". I managed to opened it by open the previous version first on a new session; what could be the problem with the first file??.
Best regards
This morning I try to open an assembly file and after 45% Loading a warning message popUp as "Error During Update: Error number 734010, This was caused while updating of type Drafting Feature Control Frame in part xxx.prt" followed by another massage "Could not open xxx.prt...the following files could not loaded...open to fail". I managed to opened it by open the previous version first on a new session; what could be the problem with the first file??.
Best regards





RE: Help!! Error 734010
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Help!! Error 734010
Regards
RE: Help!! Error 734010