×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Plastic Gear

Plastic Gear

Plastic Gear

(OP)
Hi,

i have a question regarding fits for plastic gear shafts within a plastic housing. Are there standards for fitting a plastic gear shaft into a plastic slot.
we are making a gear box with plastic gears inside of it. The tolerances of the slots which the gear shaft fits into have tolerances of +.0012/-.0008. the part is plastic and
these tolerances are really hard to hold on a plastic part.

thanks

RE: Plastic Gear

Tight tolerances on plasic parts are often a waste of time and money.

If you are rotating a round shaft stub inside of a slot, the bearing area is zero, so one or both parts will wear until the bearing area becomes finite, and the pressure on the area goes below a threshold under which wear is minimal.

It might be better, given that you really want to locate the gears, to start with a finite area and negative clearance, and allow controlled flexure of the bearing. Think two bearing sectors mounted on cantilevered flexures, all molded together of course.

That may or may not be appropriate for your actual problem, since you have given only hints about its nature and severity.

Mike Halloran
Pembroke Pines, FL, USA

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources