×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Contact analysis- a general question

Contact analysis- a general question

Contact analysis- a general question

(OP)
Hi,

I have asked this question Siemens UG NX community as well.

But, since this question is a general question related to contact analysis, I thought of asking in thsi community as well.

My mesh is of master and slave contact edges is not a confirmal mesh (i.e. the nodes of master and slave edges / region do not coincide).

In that case, is it a good practice to define two contact pairs ? That is : one pair slecting region 1 as source and region 2 as target and then another pair with source and target sapped (i.e. region 1 as target and region 2 as source).

Is this a good practise?

Or, will it make the problem over-constrained? I guess it would suit the purpose as it would create a symmetrical contact.

Thanks.


RE: Contact analysis- a general question

You shouldn't need to define two contacts for a single location, that would be redundant. Simply define what you initially stated, with the smaller face as the source and the region it will come into contact with as the target. Under Definition -> Behavior you can set the contact to behave symmetrically, which prevents the contacting surface from penetrating the target and same for the reverse. I recommend just defining your single contact condition and observing the results with the Behavior set to "Program Controlled" first and see how it turns out.

RE: Contact analysis- a general question

There is a good discussion of this in section 3.5 in the Contact Technology Guide in the Mechanical APDL Manual

Rick Fischer
Principal Engineer
Argonne National Laboratory

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources