Assembly constraints question
Assembly constraints question
(OP)
Using NX 7.5.
Today, I was constraining some new components to a fully constrained large assembly. Because of the size of the assembly, I just opened the components in the area of concern. When I created the constraints for the new components the other components moved as if they were unconstrained. When I opened the rest of the assembly everything moved back to the correct position. Is there anyway to prevent this?....Thanks
Today, I was constraining some new components to a fully constrained large assembly. Because of the size of the assembly, I just opened the components in the area of concern. When I created the constraints for the new components the other components moved as if they were unconstrained. When I opened the rest of the assembly everything moved back to the correct position. Is there anyway to prevent this?....Thanks





RE: Assembly constraints question
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.