Collinear Problem
Collinear Problem
(OP)
I am using NX version 8.5.
In sketch mode I cannot get get y horizontal
line to be collinear to Y line of axis.
Any help would be appreciated.
In sketch mode I cannot get get y horizontal
line to be collinear to Y line of axis.
Any help would be appreciated.





RE: Collinear Problem
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.