Abaqus error
Abaqus error
(OP)
Dear all,
Can anybody please explain this nature of the error. what is the reason of this error and how can i rectify it. The simulation ran for some time and gave this error, there were no warnings. "Process terminated by external request (SIGTERM or SIGINT received)." I am unable to find the reason behind this error.
Thank You.
Can anybody please explain this nature of the error. what is the reason of this error and how can i rectify it. The simulation ran for some time and gave this error, there were no warnings. "Process terminated by external request (SIGTERM or SIGINT received)." I am unable to find the reason behind this error.
Thank You.





RE: Abaqus error
You must have pressed the "Kill" button in the Job Monitor.
The SIGTERM is usually a generic signal for program termination, and as suggested it was invoked by external request, aka externally killing the process.
Hope it helps you out.
Regards
RE: Abaqus error
Thanks for the reply. but i didnt kill the process, the simulation was running and this error popped up and simulation stopped. can the reason be that my computer is not able to handle so much high computation so it is getting crashed?? help me find the solution.. ??
RE: Abaqus error
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083