Formulas
Formulas
(OP)
Hello all,
Just making a rather large assembly and trying to make my life easy (aren’t we all) I was hoping somebody could help.
Is it possible to write a formula whereby you set a few parameters like bigger than 100 smaller than 120 and another parameter like bigger than 121 smaller than 140 and depending on the outcome it would open the relevant file and place it in the assembly?
I can do the formula and make it the correct size according to my parameters but I really want to make some standard parts that can be used.
Does this make sense? Is it possible?
Thanks for everybody’s help!
Just making a rather large assembly and trying to make my life easy (aren’t we all) I was hoping somebody could help.
Is it possible to write a formula whereby you set a few parameters like bigger than 100 smaller than 120 and another parameter like bigger than 121 smaller than 140 and depending on the outcome it would open the relevant file and place it in the assembly?
I can do the formula and make it the correct size according to my parameters but I really want to make some standard parts that can be used.
Does this make sense? Is it possible?
Thanks for everybody’s help!





RE: Formulas
But if you specify what version of NX your are on maybe someone has other options for you
RE: Formulas
Assemblies > Context Control > Find Component > By Size (larger than or smaller than)
...once selected, then
Assemblies > Context Control > Open Components (ie open the components you just selected)