I am confused about whether or not Inventor LT has any sheet metal or part flatten capability. In most the documentation they don't say anything about it however in their knowledge base they have info listed directly under LT on using the sheet metal capabilities. I have downloaded the demo suite and cannot find any of these tools. Is this just info put into the wrong section in the knowledge base? http://knowledge.autodesk.com/support/inventor-lt/...
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
A number of terms like “digitization”, “digital twin”, and “digital thread” have started to emerge in the product design world. While these terms have loose and varying definitions, the core ideas that underpin each of these concepts are becoming increasingly important to successful product development. Download Now
Over the past few years, there has been growing interest among industrial companies and solutions providers with regards to Product Innovation Platforms, where design, manufacturing and IoT tools are bundled into a single software package. Download Now