NX8.0 Change Dimension text to horizontal and as a tolerance
NX8.0 Change Dimension text to horizontal and as a tolerance
(OP)
Hi Forum Friends,
I like to change a Feature of Size, vertical, along a vertical edge to a horizontal tolerance information on the same place where the dimension text of vertical was before.
I know, it is normally not possible, but in this case the Engineer needs an additional view for the machine shop guys.
See attached files.
1.) wish-horizontal_dim_w_tol.jpg shows the original
2.) wish-horizontal_dim_w_tol_2vert.jpg, shows what I like. The numbers are phantasy but I like to have this style.
Something changes here in the upload, I hope you can see this.
Thanks Bogdan
I like to change a Feature of Size, vertical, along a vertical edge to a horizontal tolerance information on the same place where the dimension text of vertical was before.
I know, it is normally not possible, but in this case the Engineer needs an additional view for the machine shop guys.
See attached files.
1.) wish-horizontal_dim_w_tol.jpg shows the original
2.) wish-horizontal_dim_w_tol_2vert.jpg, shows what I like. The numbers are phantasy but I like to have this style.
Something changes here in the upload, I hope you can see this.
Thanks Bogdan





RE: NX8.0 Change Dimension text to horizontal and as a tolerance
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX8.0 Change Dimension text to horizontal and as a tolerance
RE: NX8.0 Change Dimension text to horizontal and as a tolerance
----
kukelyk
RE: NX8.0 Change Dimension text to horizontal and as a tolerance
----
kukelyk
RE: NX8.0 Change Dimension text to horizontal and as a tolerance
RE: NX8.0 Change Dimension text to horizontal and as a tolerance
Regards,
Tomas