User Command migration to V8i
User Command migration to V8i
(OP)
I am not a code writer, but the user commands in V7 were so simple I made many. but now that I have been trying to move to v8i I can't seem to find a way to replicate them. Have they been completely dropped?





RE: User Command migration to V8i
Sorry to be the bearer of bad news.
Regards,
Bob Mecham
Training | Consulting | Programming
www.EnvisionCAD.com
Facebook: http://www.facebook.com/EnvisionCAD
Twitter: http://twitter.com/envisioncad
Youtube: http://www.youtube.com/user/envisioncad