Unexpected Error 193
Unexpected Error 193
(OP)
Hello to all,
This was the first time that happened. I ran a job, that aborted a while after, then I tried to open the monitor to read the status file etc, but Abaqus crashed down and turned off. It only happens with any job (I created others to test it out) of a specific model (I even created a copy of that model and tried to open its job's monitor, but it crashes anyway) when I try to open the monitor.
I searched on the forum too, but it didn't help me. Anyone has any ideas of what happened here?
Gratefull
This was the first time that happened. I ran a job, that aborted a while after, then I tried to open the monitor to read the status file etc, but Abaqus crashed down and turned off. It only happens with any job (I created others to test it out) of a specific model (I even created a copy of that model and tried to open its job's monitor, but it crashes anyway) when I try to open the monitor.
I searched on the forum too, but it didn't help me. Anyone has any ideas of what happened here?
Gratefull





RE: Unexpected Error 193
Error in job SC1NDC: The executable C:\Program aborted with system error code 65533
I'm searching on the internet, but no luck.
RE: Unexpected Error 193
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083