In NX 8.5 can a view or section be rotated after it is placed?
In NX 8.5 can a view or section be rotated after it is placed?
(OP)
If a view is taken at 45 degrees can it be shown horizontal on the drawing
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
In NX 8.5 can a view or section be rotated after it is placed?
|
RE: In NX 8.5 can a view or section be rotated after it is placed?
but you place/upload any image or part,it's more better to understand here.
Mimnesh,
RE: In NX 8.5 can a view or section be rotated after it is placed?
This will rotate the view to whatever angle you want.
Khimani Mohiki
Design Engineer - Aston Martin
NX8.5