Need some advanced training
Need some advanced training
(OP)
I have been on UG for the past 13 years. The last training I went to was freeform modeling in 2006. What or where can I go to learn "best practices" for things like the "reuse library" and other changes and advancements? I look at the courses offered and have been thru most of them way back, that it seams 90% of my time would be wasted just to hit some of the newer features. I know I could be doing things better and faster.
Mold designer currently running NX8
Mold designer currently running NX8





RE: Need some advanced training
These sort of follow the book, but our trainers know enough to deviate from the material and show the newer functionality and what the users need to see.
Otherwise there's the Siemens and other resellers Youtube videos.
We have a Vimeo one: http://vimeo.com/phoenxplm/videos which is growing all the time.
Anthony Galante

Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.1
RE: Need some advanced training
Please add more videos..
RE: Need some advanced training
Planning on adding more, but it takes time (surprised me how long it takes to make a 'simple' video).
Some suggestions of what you'd like to see would be appreciated.
Can't guarantee we'll do them, but you never know.
I'm working on what I think has to be a series about Drafting Templates, but my day job gets in the way!
Anthony Galante

Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.1
RE: Need some advanced training
Yes I was referring to the website.. I shared it with couple of designers .. They instantly loved the videos.. They suggested, if they can have some sync modeling, basic and adv surfacing , Flexible Printed Circuit Design module..