Compass movement limitation
Compass movement limitation
(OP)
Hello everyone,
In a assembly mode, I need to move a lot of instances for a new position. I realized that compass could move up to 50 instance at time (plus than 50 instances, compass will gray out). Is this a software limitation or bug? Is there anyway to bypass this limitation?
Regards
Richard
In a assembly mode, I need to move a lot of instances for a new position. I realized that compass could move up to 50 instance at time (plus than 50 instances, compass will gray out). Is this a software limitation or bug? Is there anyway to bypass this limitation?
Regards
Richard





RE: Compass movement limitation
Try this: Tools + Options + General + Display, and Navigation page. Increase the LIMIT DISPLAY OF MANIPULATION TO XXX ELEMENTS. I think 50 is the default value.