Part family item description updating in NX-TCE
Part family item description updating in NX-TCE
(OP)
I created part families for a Bolt in NX-6 integrated with Teamcenter, now I would like to add description for each family member like .190-32unf-3A_.625GRIP_1.032L based on the thread type and bolt length.
I added DB_PART_DESC from Attributes (Pull-down) and entered the description for each part in spread sheet. Updated each family members and status shows successfully updated. However when I check Item description in Teamcenter for each family members I does not updated.
Suggest me on this issue.
I added DB_PART_DESC from Attributes (Pull-down) and entered the description for each part in spread sheet. Updated each family members and status shows successfully updated. However when I check Item description in Teamcenter for each family members I does not updated.
Suggest me on this issue.





RE: Part family item description updating in NX-TCE
Someone else may have other suggestions but this was my experience.
Jurgen
NX8, NX9 TC8.3 TC10.1