Help on modeling
Help on modeling
(OP)
Hi,
as you can see from the image attached, I'd like to obtain the result as indicated.
What suggestions can give me ?
I've tried rplace face, but nothing.
I need to split the body, make the replace face and unite again ?
Attached also the part.
as you can see from the image attached, I'd like to obtain the result as indicated.
What suggestions can give me ?
I've tried rplace face, but nothing.
I need to split the body, make the replace face and unite again ?
Attached also the part.
Thank you...
Using NX 8 and TC9.1





RE: Help on modeling
It worked for me in NX8.5
Ronald van den Broek
Mechanical Engineer
Cad Environment Coordinator
Wärtsilä, Propulsion Services
NX8.5.3 / TC9.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5
RE: Help on modeling
Ronald van den Broek
Mechanical Engineer
Cad Environment Coordinator
Wärtsilä, Propulsion Services
NX8.5.3 / TC9.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5
RE: Help on modeling
Thank you...
Using NX 8 and TC9.1