Applying an English Thread to a Metric Part in NX 7.5, is it possible?
Applying an English Thread to a Metric Part in NX 7.5, is it possible?
(OP)
Simple question about NX 7.5 - can some apply a English Measurement Thread (in this case 3/4-16 UNF) to a Metric Measurement NX Model? I understand the ability to show the thread with English Measurements may be nil in Drafting, but I would like to get the Model 'looking right'.





RE: Applying an English Thread to a Metric Part in NX 7.5, is it possible?
RE: Applying an English Thread to a Metric Part in NX 7.5, is it possible?
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli