Macro help?
Macro help?
(OP)
I need a macro to set parameters in a drawing based on the model you have linked.
I am looking to set the following from model attached in front view on sheet 1.
modlefilename
modledesc
modlepartnumber
modlerev
can any one help me out with this?
I am looking to set the following from model attached in front view on sheet 1.
modlefilename
modledesc
modlepartnumber
modlerev
can any one help me out with this?





RE: Macro help?
RE: Macro help?
Did you tried something?
Searching the forum, I found this.
Regards
Fernando
https://picasaweb.google.com/102257836106335725208
https://picasaweb.google.com/103462806772634246699...